


Venetian plaster for double height halls in Dubai villas gives the tallest walls in the house an even, stone like depth, and Zavoré lays it with its own artisans working from safe access at full height. The challenge in these entrance halls and stairwells is scale, so we plan colour, access and the order of work carefully to keep the finish consistent from the floor to the top of the wall.
The full sequence of a job is set out on our Venetian plaster installation page, and our work around the city is described under Venetian plastering in Dubai. For more on the material and its tones, see our Venetian plaster, and for halls in Abu Dhabi, Sharjah and beyond read Venetian plastering in the UAE.
Many Dubai villas open into a hall that rises through two storeys, often with a sweeping stair, a gallery landing and a chandelier at the centre. These are the walls every visitor sees first, and they are usually the largest uninterrupted surfaces in the house. Plain paint across such an expanse tends to look flat, while wallpaper on a tall wall means many vertical seams.
Venetian plaster has no seams at all. Thin coats of lime and finely ground marble are laid and burnished by hand, so the wall gains soft movement and a gentle sheen. Daylight from high windows travels across that surface through the day, and in the evening the chandelier picks out the depth of the layers. The result feels calm and grand without needing pattern or ornament.
A wall that rises through two floors cannot be plastered from a stepladder. Safe working access, usually a mobile tower or a scaffold, has to be planned around the stair, the gallery and the floor finish. We look at all of that at the survey, including where access equipment can stand without marking stone or timber, and how it can move along the wall as each section is finished.
Access also affects timing. Moving a tower or adjusting a scaffold takes time, and the plaster has to be worked while each coat is at the right stage. Planning the layout in advance means the artisans can reach the whole height of a section in one session rather than stopping halfway. Floors, balustrades and stair treads are protected before any work starts.
Consistency is the real test of a tall wall. Three things matter most. First, the plaster for each face is tinted to the same approved sample so the colour does not drift between batches. Second, a face is worked as one continuous section from corner to corner, with any pauses placed at natural breaks such as an internal corner, a door frame or a change of plane. Third, the same artisans carry the work from first coat to final wax, so the pressure and rhythm of the trowel stay even.
Lighting during the work matters as well. Tall halls often have mixed light from high windows and spotlights, so the artisans check each coat from several angles before moving on. That care is what stops patchy sheen or visible laps appearing once the wall is finished.
A colour that looks gentle on a small board can read much stronger across a wall five or six metres tall. Many owners find a tone one step lighter than their first choice works better at full scale. Pale stone, warm sand and soft greys suit most halls, while a deeper shade can work where the hall is very bright. Choose from 48 house colours or give us any NCS reference.
Sheen is a separate decision. Classic Venetian plaster gives a soft glow. A polished plaster finish brings a higher shine that suits formal halls with marble floors. Marmorino stays calmer and more matt, which can suit a modern villa with clean lines. Hold the sample board high on the wall as well as at eye level, morning and evening, before you decide.
Most problems start with the base. Large plasterboard walls need every joint reinforced and the right primer, otherwise fine lines can appear later. A wall that is not flat will show dips once polished, and on a tall surface those dips catch the light from the high windows. Rushing is another risk, because laying a coat before the last one is ready can spoil the finish. Careful preparation and a steady pace avoid both.
It depends on the area, the height, how much access equipment has to move and how much preparation the walls need. Each coat must dry before the next, and the final burnish and wax are done patiently. We plan the work in blocks of days so the same artisans remain until the hall is complete, and dates are fixed after the survey once the sample and price are agreed.
Yes. Stair walls are a natural place for it, because people pass close by and see the depth of the finish. Access is planned around the treads and balustrade, and both are protected before work begins. The wall must be flat and properly primed first.
There should not be. Each face is worked as one continuous section, with any pause placed at a corner or a natural break, and the plaster is tinted to one approved sample. The same artisans see the work through, so the burnish stays even.
We do not publish set prices. The cost depends on the area, the height and access needed, the condition of the walls and the finish chosen. Send photographs and rough measurements, then after the survey we fix a clear price before any dates are agreed.
Most towers and communities have management rules on working hours and deliveries, so check with yours before access equipment arrives. If you rent the villa, ask your landlord first, as Venetian plaster is a lasting change.
To plan the hall in your villa, ring +44 7592 929191 on Monday to Saturday, 9am to 6pm UK time, or email sales@zavore.co.uk with photographs of the hall and stair, rough measurements including the wall height, and the address. A sample board held high on the wall is the surest guide to colour.
How Venetian plaster, marmorino and limewash suit modern Arabic interiors in Dubai, with advice on arches, niches, majlis walls, mashrabi...
DubaiWhy one Venetian plaster feature wall suits Dubai Silicon Oasis apartments and townhouses, which wall to choose and how the job is prepar...
DubaiA guide to desert colours for Venetian plaster in Dubai homes, from sand and oat to terracotta and umber, and how to choose a shade that ...
DubaiHow concrete effect plaster and marmorino suit Al Quoz galleries, warehouse units and creative workplaces, with the survey, sample and pl...
DubaiHow Venetian plaster works in the creekside apartments, residences and hotels of Al Jaddaf and Culture Village, from feature walls to col...
DubaiWhy the weeks after handover suit replacing builder paint in a new Dubai villa, what to settle at snagging and which rooms to plaster first.
Providing luxury finishes for the most prestigious addresses in the world
Venetian plaster, limewash, microcement, tadelakt, metallics, sculptural plaster and gold leaf, supplied and installed by our own team, with Venetian plaster taught at our Birmingham studio.
One list, run by the people who make the material. No noise, and nothing we would not want to read ourselves.
We email as the house has something worth saying, never daily. Unsubscribe from any email, or reply STOP to any text. We never pass your details to anyone.