


Marble effect plaster walls give an Abu Dhabi villa or apartment the depth and soft veining of polished stone without slabs, grout lines or heavy fixings. Zavoré lays this lime based finish by hand in homes across Abu Dhabi, Al Ain and the wider UAE, using our own artisans. It is slaked lime and ground marble pressed on in thin coats and burnished, so the wall reads as marble while being a plaster rather than stone.
The material itself is described on our Venetian plaster page, and the city is covered on Venetian plastering in Abu Dhabi. This post gathers the questions homeowners in the capital raise most often when they want a marble look, from curved stair halls to choosing a colour that sits happily with the floor.
No. Real marble is quarried, cut into slabs or tiles and fixed to the wall, with joints between each piece. Marble effect plaster is lime mixed with marble powder, tinted, laid with a flexible steel trowel and then burnished until it shows depth and a gentle sheen. The clouding and veining come from how each layer is worked, which is why no two walls turn out quite the same.
That difference shows up in daily life. A plaster wall has no grout to clean and no seams to line up. It feels warmer to the hand than cut stone and tends to look softer in a living room or majlis. It is a wall finish only, protected with a natural wax buffed in at the end, so it is not something to walk on or to use as a worktop.
The capital has a long affection for pale stone. The white marble of the Sheikh Zayed Grand Mosque sets a calm, restrained tone that many people carry into their homes, and villas in Al Bateen, Khalifa City and Al Mushrif often have tall entrance halls and generous majlis rooms. Those are the spaces where a marble look feels most at home.
Apartments benefit too. In a tower on the islands, a single marble effect wall facing the glazing can give a modern room the feeling of stone without crowding it.
Yes, and this is one of the strongest reasons to choose plaster over stone. Bending real marble around a curve means templates, thick slabs and careful fixing, and the joints still show. A hand laid lime finish simply follows the shape, so a round stair hall, an arched doorway or a column in a villa entrance can be finished as one unbroken surface from floor to ceiling.
Curves still need a sound, smooth base. At the survey we look at how the curve was formed, whether in blockwork, render or bent plasterboard, and whether any joints need reinforcing and priming first. Tall walls and stairwells normally need scaffolding or a mobile tower, and that is planned well ahead of the first coat.
Most homes in the capital already have marble, limestone or porcelain underfoot, so choose the wall with the floor in view. Ivory, sand and soft stone shades let a veined floor lead the room. A wall a little warmer or a little deeper than the floor gives contrast without fighting the pattern, whereas copying the floor exactly can leave a room feeling flat.
There are 48 house colours to choose from, or you can give us any NCS reference, and the plaster is tinted to whichever sample you approve. Stand the sample board on the floor against the wall at breakfast and again after dark, because sunshine and lamplight shift stone tones more than most people expect.
Not every marble look is glossy. A high polish suits formal rooms and flat walls, and our page on polished plaster in Abu Dhabi explains it in detail. A satin finish sits between gloss and matt and feels gentle in a bedroom. For an open, pitted stone face, travertino in Abu Dhabi reads like cut travertine, with its pores and banding put in by hand, and suits entrance halls, columns and fireplace walls, though it should be kept away from a hob.
Most problems begin before the plaster does. A wall that is out of flat will show every hollow once burnished. Plasterboard with unreinforced joints can crack along its seams. A partition that moves is a poor base for any rigid finish. And Venetian plaster placed inside a shower will not last, which is why tadelakt, or microcement over a waterproofed wall, is used there instead.
Wet lime is caustic, so floors, joinery and stone thresholds are covered before work starts. The building, the climate and the way each room is used are discussed on site at the survey, rather than promised in an email beforehand.
You send photos, any drawings and rough sizes for the walls, and we talk them through with you. A survey follows before any figure is given, because the base and its flatness change the work. Then comes a sample in your colour to approve, and only once the sample and price are signed off are dates agreed. Our Venetian plaster installation page sets out the stages in more depth.
Each job is booked as a run of consecutive days, so one team of artisans stays from primer to wax and lays every layer in its proper turn. How many days depends on the walls and is settled at the survey. Villa communities and towers usually have management rules about working hours and deliveries, so ask yours early, and tenants should have the landlord's agreement first.
No. It goes on in thin layers directly over a prepared wall, so it adds almost no weight and needs no fixings or frame. That makes it a practical choice for curved walls, columns and upper floors, where stone cladding would be bulky.
It can be tinted to sit beautifully beside it. Pick one of 48 house colours or an NCS reference and we make a sample, so the wall colour is judged against the actual floor before any work is booked.
Yes. Our own artisans work in villas and apartments right across the capital, in Al Ain and throughout the UAE. A few photos, rough wall sizes and the address are all we need to start the conversation.
On a basin wall or in a powder room, yes, once it is waxed. Inside the shower enclosure it is the wrong material, and tadelakt, or microcement over a waterproofed wall, is the finish to choose there.
If you would like a marble look in your home, ring +44 7592 929191 between 9am and 6pm UK time, Monday to Saturday, or send photos, rough sizes and the address to sales@zavore.co.uk. Ordering a sample board is a simple first step.
An outline of what limewash training covers about mixing limewash and the risks of slaking lime, and how to ask Zavoré about it.
BasementsA guide to decorative finishes for London basements, covering media rooms, gyms and wine rooms, why waterproofing must come first, and wh...
CheshireAn in depth guide to seamless microcement and tadelakt bathrooms for homes across Cheshire, and how to choose between them.
CheshireA guide to polished plaster and other decorative finishes for the large modern homes of Wilmslow and Alderley Edge, and where they fit in...
CheshireChester and the Cheshire countryside are full of timber framed, Georgian and Victorian buildings. This guide explains why lime finishes s...
Greater ManchesterHow microcement floors work in kitchen extensions across Greater Manchester, from the screed underneath to underfloor heating and everyda...
Providing luxury finishes for the most prestigious addresses in the world
Venetian plaster, limewash, microcement, tadelakt, metallics, sculptural plaster and gold leaf, supplied and installed by our own team, with Venetian plaster taught at our Birmingham studio.
One list, run by the people who make the material. No noise, and nothing we would not want to read ourselves.
We email as the house has something worth saying, never daily. Unsubscribe from any email, or reply STOP to any text. We never pass your details to anyone.